How To Install Mower Blades Correctly

Find the nut that holds the mower blade to the deck. The Blade is Dented or Bent.

Which Side Of The Lawn Mower Blade Is Up Planted Shack

One of the best ways to determine the proper orientation of a mower blade is to pay attention to how the old blade was mounted.

How to install mower blades correctly. These blades usually have 2 sides an angled side and a flat side. There is a stamp in front of each blade to place the blade properly. Leave this as is and place a wood block inside the deck next to the edge of a blade that has to be aligned.

Hold the blade with a leather glove then remove the bolt or bolts holding it to the mounting plate. Since the blade damaged due to being upside down we should replace it properly very quickly. Blades can get damaged over time.

Plus a couple tricks and tips. Disengage the blade lever and lower the mower deck. Dont get that blade upside-down.

Sometimes the easiest way to tell if theres a mower blade issue is looking at the blade itself. Which side of the lawn mower blade is up. If there are any sizable dents or if the blade is bent it needs to be sharpened or completely replaced.

This video shows how to replace a blade on a riding lawn mower. Depending on your situation detach the mower deck by removing the connections with the mowers frame. Most blades have this stamp.

Consider placing a wooden block under the blade to prevent it from moving around. A dull or bent mower blade tatters grass tips rather than making a clean cut leaving the law. Mark the bottom of the blade with a permanent marker grease pencil or spray paint.

The cutting edge is sharpened to a point with an. Which makes your replacement work easier. That way you can install the sharpened blade right-side up later.

Use a ratchet or socket wrench to loosen the nut until the mower blade. Most new blades have wording stamped on the blade to indicate which side should face the ground when you install. If it rock then heres what you should do- ensure that its fitted on the shaft correctly and tight all the securing bolts using a socket wrench.

How to put a blade on and take it off. Use a socket wrench turning left for a standard bolt and right for a reverse-threaded one. Below are some ways to accurately represent the blade of this mower.

To perform the wobble test hold one first of the mower blade firmly and the deck with your other hand. Disconnect the spark plug cables. Turn the mower blades slowly until one points forward and one points backward.

Installing a lawnmower blade incorrectly can sometimes result in it not even cutting the grass at all. Loosen the retaining bolt on the blade. Make sure that the mowers spark plug is disconnected and tilt the mower so that you can access the blade.

For your lawnmower to perform in tip-top shape and ensure that you get the job done you first need to install your blades properly. Lawn mower blades are sharp so youll want to keep your hands protected. In this video I demonstrate on my Troy-Bilt Pony how to change your riding lawn mower blades without taking off your deck.

How to Install Riding Lawnmower Blades step by step Step 1. I switch out my regular blades fo. We have to find out.

How to Know if You Have Your Lawn Mower Blades on Correctly Step 1. Turn the blade and find the cutting edge on one end.

How To Change A Lawn Mower Blade 7 Steps With Pictures