How To Remove Mower Blades Victa

You may need to tip your mower to remove or replace blades which can be done during a lawn mower service. To avoid internal oil spillage in 4-stroke mowers ensure the spark plug faces upwards to avoid dousing it in fuel.

Victa Lawnmower Fitting New Blades Youtube

Remove the muffler from the front of the engine by using a screwdriver to disconnect the 2 clips top and bottom holding it in place.

How to remove mower blades victa. You may need to tip your mower to remove or replace blades which can be done during a lawn mower service. Either reach behind the blade carrierof the mower and undo the blades requires socket wrench and allen key or if this is not easily accomplished you can remove the entire blade carrier from the mower by loosening the main bolt holding it in place with a socket wrench. You need to heat the hub and strike it with a hammer in the same direction as removing the blade nut.

Use a socket wrench turning left for a standard bolt and right for a reverse-threaded one. This Tutorial Demonstrates the process of replacing the blades on a victa lawn mower should be similar between models and brands Click Below For More Infoma. Remove the engine from the lawn mower click here for a tutorial.

Loosen the retaining bolt on the blade. Ensure that the mower is drained or low on fuel and lawn mower oil to avoid spills. Ensure that the mower is drained or low on fuel and lawn mower oil to avoid spills.

Start the engine carefully with feet well clear of blades. Do not tilt the mower when starting the engine. Mow only in good daylight.

Removing the blade holderhttpsyoutubedRid. To avoid internal oil spillage in 4-stroke mowers ensure the spark plug faces upwards to avoid dousing it in fuel. Lawn mower blades are sharp so youll want to keep your hands protected.

Before undoing the blade tip the mower on. Remove Spark Plug lead for safety reasons. Learn how to remove a Victa engine from the main chassis of the lawn mower.

When looking at the blade boss you will notice on one side there is a hole fill this with WD-40. Place the boss over the anvil and hit it with a hammer rotating the blade boss as you do so this should loosen it and allow it to be removed. They are hard to remove and you will undoubtably damage it during removal but.

Keep hands and feet away from rotating parts beneath mower when engine is running. Consider placing a wooden block under the blade to prevent it from moving around. This insures oil does not flow into the intake or exhaust and cause trouble later.

Step 2 Remove the carburetor by disconnected any hoses as well as the ignition wires then twist it off the engine. This Video Demonstrates how to easily remove a Victa Blade Boss Click Below For More Information Visit our site for more tutorials Parts and lawn mowers for. Lift up the mower with the front wheels facing skyward.

Stop the engine whenever you leave the mower even for a moment. The blades need removing from the blade carrier before sharpening. This video is also associated with the followingOil change on mowerhttpsyoutubePyp965w7mmIVicta mower.

Either disconnect the fuel line and remove the top cover or empty fuel from the mower before turning it onto. To remove the blade you must turn the blades retaining bolt to the left or counterclockwise. Remove the blade carrier with blades attached by undoing the bolt in its center which holds it.

Either remove the main securing bolt and remove bolts securing blades or remove blade bolts while still attached to the mower.

Battery Powered Mowers And Lawn Equipment Victa